Informationen

flow transducer | LABO-F012-I/U/F/C

Produktbeschreibung

LABO-I/U/F/C: evaluation electronic with analog output

general information:

The sensors of the LABO-F012 family are used for monitoring of non-viscous fluids (for gases upon request). They are fully equipped with electronics in a sensor housing with a diameter of 12 mm and a M12x1 round plug outlet. The 16-bit processor carries out temperature compensation and linearisation of the calorimetric signal (measurement of the heat removal at the sensor tip due to the flowing medium).

The LABO-F012 electronics transmit the result as:

analog signal 0/4 mA to 20 mA (LABO-F012-I)
analog signal 0/2 V to 10 V (LABO-F012-U)
frequency signal (LABO-F012-F) or
pulse output / x litre (LABO-F012-C)

A model with switching output is available under designation LABO-F012-S.

If desired, the range end value can be set to the currently existing flow using "teach-in". If the transmitter is ordered in a specific T-piece, it can also be adjusted in l/min. Here, it should be noted that the flow speed is measured at only one point in the tube cross-section.

complete transmitter in 12 mm housing
for various nominal widths of tube the same transmitter
signal proportional to the flow speed
4...20 mA or 0...10 V or frequency output
adjustable working range
user-configurable via plug pin (teach-in)
can be used for various tube cross-sections
simple to use

specifications:

appliance:	flow, control
medium:	water (oils and gases upon request)
measuring range:	2 cm/s to 150 cm/s (water), 3 cm/s to 300 cm/s (oil)
connection:	plug-in sensor Ø12 mm
basic data:	PN 40 bar (stainless steel pinch screwing), PN 10 bar (plastic cone with union nut), temperature of medium -20°C to +70°C
electrical data:	supply voltage 24 V DC ±10 % power consumption <1 W