Informationen

flow switch | LABO-F012-S

Produktbeschreibung

LABO-S: evaluation electronic with switching output

general information:

The sensors of the LABO-F012 family are used for monitoring of non-viscous fluids (for gases upon request). They are fully equipped with electronics in a sensor housing with a diameter of 12 mm and a M12x1 round plug outlet. The 16-bit processor carries out temperature compensation and linearisation of the calorimetric signal (measurement of the heat removal at the sensor tip due to the flowing medium).

The electronics of the LABO-F012-S are a versatilely configurable limit switch.

The switching value can be set by the user via teach-in. All other values have been preset at the factory, but can be modified by the user with the help of the optionally available ECI-1 interface and a PC.

complete flow switch in 12 mm housing
can be used for various tube cross-sections
configurable switching point via plug pin (teach-in)
simple to use
same construction type available as flow transmitter, temperature switch / transmitter or level switch

specifications:

appliance:	flow, control
medium:	water (oils and gases upon request)
measuring range:	2 cm/s to 150 cm/s (water), 3 cm/s to 300 cm/s (oil)
connection:	plug-in sensor Ø12 mm
basic data:	PN 40 bar (stainless steel pinch screwing), PN 10 bar (plastic cone with union nut), temperature of medium -20°C to +70°C
electrical data:	supply voltage 24 V DC ±10 % power consumption <1 W